Wagner HIGH PERFORMANCE AIRLESS SPRAYER Bedienungsanleitung PDF herunterladen (Seite 27)

Problem Cause Remedy

Spray gun won't shut off. Worn ball or seat. Take to Authorized Wagner Service Center.

Foreign matter or paint Take to Authorized Wagner Service Center.

buildup or dried paint between

ball and seat. (Caused by

improper cleaning of gun.

Spray gun leaks. Worn or dirty internal parts. Take to Authorized Wagner Service Center.

(Caused by improper cleaning

of gun.)

Tip assembly leaks Assembled incorrectly. Check assembly.

Worn seal. Replace seal.

Spray gun won't spray. Spray tip, gun filter or tip Clean spray tip.

filter plugged. Clean or replace gun filter.

Clean or replace tip filter.

Spray tip in Clean position. Put tip in Spray position.

Paint tailing. Pressure is set too low. Increase pressure.

Gun, tip,or suction filter plugged. Clean filters

Suction tube loose at Tighten suction tube fitting.

inlet valve.

Tip worn. Replace tip.

Paint too thick Thin paint

Thermal overload tripped Motor over heated. Allow to cool 15 to 30 min.

Extension cord too long or Allow to cool, replace cord with one shorter or

too small gauge. larger gauge.

Paint build up on motor. Clean paint from motor.

Restart under pressure . Restart in Prime mode.

Unit sitting in hot sun. Move to a shady location.

TROUBLE SHOOTING

Follow Pressure Relief

Procedure before per-

forming any of these

operations since the

motor will restart with-

out warning when the

motor cools sufficiently

WARNING

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33

Keine Kommentare

Wagner HIGH PERFORMANCE AIRLESS SPRAYER Bedienungsanleitung Seite 27